Questions & Answers for: Nissan Pickup rough idleing

1997 Nissan Hardbody has rough idle/surges/stalls Thank You in advance for any help you can provide. Vehicle: 1997 Nissan Hardbody 2.4L(KA24E)4 cyl. 5 speed, 211,000 miles. Motor starts fine but the ...

Ad

Question about 1997 Pickup

1 Answer

rough idle I have a 1996 pickup 125,000 miles on it. It has had a rough idle for years, sometimes it will rough idle till it goes dead. I took the air filter off and at the back of the motor there was

Ad

1993 nissian p/u run rich and it running real rough when its idling its it idles rough and i can smell the gas real strong If it is a carb engine have the air fuel mixture corrected by adjusting the ...

85 nissan pickup runs rough at idle my pickup runs rough at idle but has great power and starts everytime with ease ive replaced virtually all the vacuum hoses and the intake manifold gasket ive ...

hello, my 85 nissan pick up suddenly started hello, my 85 nissan pick up suddenly started running roughly. the engine rpm seems to rise and fall when at idle and when driving it ran a little roughly. ...

97 nissan pickup, idles rough charcoal in purge 97 nissan pickup, idles rough, charcoal in purge line is this the problem? I found the charcoal all the way up at the front by the carb. you answered ...

rough Idle...97 pick up replaced egr, maf, and map sensor and it still is running rough and wanting to cut off...any ideas check for inlet manifold vacuum leak, spray some lube like RP7 into that area

...ACCELERATE BUT WHEN YOU SHIFT BACK TO 5TH AND LEVEL OFF IT SLOWLY DECRESES IN SPEED.IT ALSO HAS A ROUGH IDLE AND SOME TIMES BACK FIRES UNDER HEAVY ACCELERATION AND HIGH RPM IN LOW GEARS For this ...

1986 nissan pickup z24i 5 speed idles like a chopper on steroids and revs rough but at about 3000 rpm it acts like it hits a rev limiter. the motor has maybe 150 miles on the motor rebuild. i can ...

Question about 1992 Pickup

1 Answer

1992 rough idle rough idle smooths out at higher rpm's Could be anything. Vacuum, valves, rings, tune up. Check vacuum lines. Then check compression before you do a tune up. If you have bad ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...