Questions & Answers for: Nissan Pickup rough idle

Ad

...rough idle/surges/stalls Thank You in advance for any help you can provide. Vehicle: 1997 Nissan Hardbody 2.4L(KA24E)4 cyl. 5 speed, 211,000 miles. Motor starts fine but the idle is rough and the ...

Ad

Question about 1997 Pickup

1 Answer

rough idle I have a 1996 pickup 125,000 miles on it. It has had a rough idle for years, sometimes it will rough idle till it goes dead. I took the air filter off and at the back of the motor there was

Ad

...rough and i can smell the gas real strong If it is a carb engine have the air fuel mixture corrected by adjusting the screws on the carb. Try also adjusting the idling. For EFI engines see if you can ...

...rough at idle my pickup runs rough at idle but has great power and starts everytime with ease ive replaced virtually all the vacuum hoses and the intake manifold gasket ive adjusted the valves and ...

hello, my 85 nissan pick up suddenly started hello, my 85 nissan pick up suddenly started running roughly. the engine rpm seems to rise and fall when at idle and when driving it ran a little roughly. ...

97 nissan pickup, idles rough charcoal in purge 97 nissan pickup, idles rough, charcoal in purge line is this the problem? I found the charcoal all the way up at the front by the carb. you answered ...

rough Idle...97 pick up replaced egr, maf, and map sensor and it still is running rough and wanting to cut off...any ideas check for inlet manifold vacuum leak, spray some lube like RP7 into that area

ROUGH IDLE AND SOME TIMES BACK FIRES UNDER HEAVY ACCELERATION AND HIGH RPM IN LOW GEARS For this types of problem,there are few help inks to troubleshoot the problem.Click the link below to go through

...idle just really low and rough. when irev it up it sputters untill about 3000 rpm, at 3000 rpm it acts like it has a rev limiter but at 4000 rpm it is smooth. i have checed coil, mass air flow meter ...

Question about 1992 Pickup

1 Answer

...rough idle rough idle smooths out at higher rpm's Could be anything. Vacuum, valves, rings, tune up. Check vacuum lines. Then check compression before you do a tune up. If you have bad compression in ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...