Questions & Answers for: rotor pointing 1 wire

...rotor is pointing at the right wire when at TDC for no 1 cylinder. What direction should it be pointing? Find the end of the plug wire for cylinder 1. Place the plug wire into the distributor cap. ...

...is on compression stroke and at TDC, the ignition rotor should be pointing at the tab inside cap for # 1 spark plug wire. It should point just ahead of the number one plug wire in the

...is fairly simple) once at top dead center pull dist. cap and see if rotor points directly to spark plug wire # 1 on cap...If not loosen distributor and turn until rotor is pointing to #1 ...

...rotor is "pointing" to, use a ratchet on the center bolt of the crankshaft and turn the engine over by hand (clockwise direction only as viewed from the front of the engine looking towards the ...

...1. If the rotor keeps lining up wrong, remove the distributor all the way, and insert the long screwdriver in the hole. Turn the oil pump drive a little, then try the distributor again.4 Install the ...

rotor position: should be either pointing to No. 1, or will be pointing directly opposite if you are on the exhaust stroke (TDC) of No. 1. Turn the crank one revolution, and come back to the zero mark

...actually pointing toward # 1 cylinder, just the tab under cap that goes to # 1 spark plug wire. # 1 cylinder needs to be at TDC on compression stroke, and rotor pointing at # 1 wire tab under

rotor on #1 mark! . (3 tries, sure) set clamp bolt, plug in side plug. Cap back on wires same as before, do not scramble the wires. new rotor on installed wrong, cheap rotors are just that the install

...rotor needs to be pointing at the part of the cap where the spark plug wire connection for cylinder #1 is. look in the nissan service manual. Normally you move the crank to TDC for cylinder #1 and ...

...wires Tried new cap rotor plug wire plugs brought #1 to top dead center both valves close an rotor points to # 1 plug any ideas carbon tracks around the rotor button, rotor button slipping on the ...