lines on copys when i feed through top feeder i try and wipe down the rollers and the piece near the rollers. but it keeps copying with lines on the pages There is a small strip of glass under the ...
...with a problem in that when the copy paper is going through it starts to concertina up by the roller. Any suggestions on how to fix this problem? Make sure the fuser rollers are turning, ...
...developer and use the right toner and clean the drum and its blade. You may need to clean fuser rollers for cleaner copies. Hello sir; It's time to replace drum blade at lease, or you have to ...
...marks but copys are still almost faded? was going to clean drum but am not sure where it is located? please help with any suggestions or guides. thank you Open front cover, you will see yellow knob, ...
It is making blue and red marks down the papers when it copies. I have taken out the roller part and cleaned with acohol. I would suggest taking it to a specialist if this is happening :)
...good quality paper has been tried, but problem persists. Also, paper does not get as far as feed rollers before jamming does the paper lift when u insert the paper tray? If it does the clutch that ...
...we pull the jammed piece of paper from the bottom I see slight ink marks on the paper where maybe rollers were. Any suggestions? hi did u have cheq all the paper path sensors may be any one of them ...
...common problem in that copier. The fuser unit has little pawls which seperate the paper from the rollers, they can become dislodged when customers remove jams. Another very common problem is the ...
I have a sharp AR-337 copier, On the dispaly it reads: CALL FOR SERVICE. CODE:H4-00 H4 00 Heat roller abnormally low temperature The fusing temperature does not reach 175C degrees within 30 sec of ...
...Also try to open it and clean the parts that get in touch with the paper..it may have some ink on rollers or so
Usually answered in minutes!
1,105 Questions
603 Questions
557 Questions
331 Questions
354 Questions