...ROCKER SHAFT BOLTS AND ROCKER SHAFTS..YOU CAN PURCHASE ONLY THE ONE(S) YOU NEED..BE CAREFUL WHEN YOU REMOVE ROCKER SHAFTS..THE LIFTERS CAN FALL OUT..GET A STICKY GREASE TO HOLD THEM IN ROCKER ARMS ...
Question about 2005 XL 1200 R Sporster Roadster
rocker arm shaft out of the rocker arm and remove the rocker arm. You can then get your cam into position. Now, to get rocker shaft back in, rotate the engine until the front exhaust cam has the valve
...rocker arm shaft retainer bolts to 23 ft. lbs. (32 Nm). * Check valve adjustment and install the valve cover. Tighten the valve cover bolts to 16 inch lbs. (1.8 Nm) for the 1.5L engine or to 29 inch ...
Question about 2000 XL 1200 C Sportster Custom
...rocker arm shaft out and remove the rocker arm. You may have to gently tap the rocker arm shafts out but it should not be difficult to get them out. Do not mix the rocker arms and their shafts up. ...
Question about 2000 XL 1200 C Sportster Custom
...The tappets are tight & noisy. How do i go about adjusting the TAPPETS? tappets cannot be tight and noisy at the same time . Check the rocker and rocker shaft for wear in the shaft and rocker
Rocker cover gaskets fitted. did not fix , is there a seal on the Cam shaft ? which would cause this problem yes there is a seal on the cam shaft behind the water pump pully undo that bolt you have to
...rocker shaft for a 1998 7k toyota 1800 There is no such thing as a rocker shaft. There is a cam shaft, rocker arm assembly, Rocker arm, lifter etc. If you are talking about the rocker arm assembly ...
Question about 1995 Corolla
...rocker shaft to lube cam on 1.6 the rockers lube the cam. Where does oil enter rocker shaft. Single overhead cam though the holes in the head where the cam shaft runs oil pump feeds to these holes ...
...belt. The other ones...nothing. what is the cause? the cam shaft the drives the rocker arms is all solid so if you only have one set of rockers moving it indicates a broken cam shaft after that ...
Question about 1995 Corolla
...rocker shaft out lifters started moving. reinstalled rocker shaft valves moved for couple pulls plug out then quit moving. decompressor??? I presume you lined up the rocker timing before removing the ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions