Questions & Answers for: rm 250 2003 compression

...rm 250 fouls plug in seconds.? You need to ensure that your fuel/oil mixture is correct. Roughly between 40:1 and 32:1. Usually if you mix is off, it will foul plugs quickly. You can also get a ...

Ad

...250 cleaned out tank and carb runs but will not idle 2003 suzuki ozark was sitting for months had bad gas i cleaned out tank and carb and it runs but stalls and will not idle sounds like the float is ...

Ad

how much oil needed in showa front forksfour a suzuki rm 250 2003 or 2004 210 mm from the top of the leg with the fork fully compressed and the springs removed. That's 8.25 inches

...RM 250 won't spark. The engines been taken My RM 250 won't spark, therefore won't start. The engines been taken apart and cleaned but still no luck Things to check are 1/ Short out plug wire to good ...

Correct quantity(ml) of oil per front shock(fork) for 2003 Suzuki RM250 110mm oil height in each fork tube. Remember to bleed it first to ensure all air is out the inner chamber and then measure 110mm

Question about 2003 RM 125

1 Answer

...rm 250 won't start and it is flooded how do I fix this problem. Try another spark plug. Also, make sure you have a clean air filter, and good compression. If all is well and it runs rich, (Plug burns ...

Question about 2003 RM 250

1 Answer

250 quadrunner. why does it idle up and down when it just sits there? i've rebuilt the carb 1.Intake leak 2.Old fuel the 10% ethanol is not a good fuel it attracts water.. 3.Idle slightly too high and

rm 250 ive just changed the crank shaft seal and the bike is still smoking but not as bad cud i have oil in my packing in my back box of my exhaust or have i another problem? And the bike spluters and

rm 250 and it smokes to wear there is oil resadue on my rear fender Find out what the oil to gas ratio is.sounds to me like your running to rich.If your oil to gas is correct then the next thing to do

...to 1.5 turns out, the carb floats don't seem to be jamming, what could the problem be?. hi mate i had a rm 250 with the same problem, have you done a compression test, as mine had poor ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Motorcycles Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Brad Brown

Level 3 Expert

19187 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66772 Answers

Are you a Motorcycles Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...