Question about Harley Davidson XLH Sportster 883 Hugger Motorcycles
braking teeth on the starter ring gear on cutch i was thinking teeth count of both ring and bendix and alinement of starter when cranking Note watch loose clothing and fingers in gears
Question about 2000 XLH Sportster 883 Hugger
...instances this (oil cap popping out) can be caused by excessive crank case pressure IE: cracked ring. cylinder leakdown test would answer this. Doubt an 03 whould have a cracked
Question about 2003 XLH Sportster 883 Hugger
Looking to replace an old battery on 2003 Harley Sportster. Need replacement battery ordering information. ring harley dealer,get a genuine batt they last longer,and buy a trickle charger,
Question about 2000 XLH Sportster 883 Hugger
I have a 1999 Sportster Hugger that burns a lot of oil and blows out a lot of white smoke when I first start it up. After it warms up it does not stop but it smokes a lot less. I have changed the oil ...
i have a 2002 hugger 883 i am getting fuel into the oil resivor tank.i change the oil and added the correct amount but started it up and it filled the resivor all the way up to the top andit smells ...
1996 883 harley clutch replacement does the spring plate go behind or in front of snap ring You put the spring plate on first (after putting on all the clutch disks) with it being held in the ...
oil leaking from speedo sincor oil leaking from speedo slnsor Hi Anonymous, replace o-ring. Good luck
Question about 2000 XLH Sportster 883 Hugger
...then it died. smoke comes out the tail pipe, air filter is full of oil sounds like it could be a ring problem ...
Question about 2000 XLH Sportster 883 Hugger
...the oil, rode three hours, smoke coming out t5ailpipe, tapping sound kinda sounds like you broke a ring or crank case vent plugged Had that happen to a friends Sportster after oil change.Turns out ...
Question about 2000 XLH Sportster 883 Hugger
...not fully engage or dissengage at times, all clutch adjustments are per specs, could it be the bearings Hi Sherry, The clutch adjuster screw is held in place by a bearing and the bearing is held in ...
Usually answered in minutes!
109 Questions
63 Questions
38 Questions
22 Questions