Questions & Answers for: Chevrolet Blazer ring count

...exact ratio of the front unit and match it. (ring gear teeth divided by pinion tooth count= ratio ) You may not like my answer, but I'm trying to save you time and aggravation and $.!!!! good ...

Ad

...tank. The old tank was rusted and I had a hard time taking it off and i ended up destroying the old ring and yes i have a new ring and a rubber ring. I just would like a step by step walk through on ...

Ad

...top of the motor. Replace them{fuel lines}check connections Inside the fuel line connectors are "o" rings used to seal the connection. The "o" ring has been damaged or has fallen out when the fuel ...

Question about 2001 Blazer

2 Answers

...Remove the pressure regulator mounting screw. Remove the fuel pressure regulator assembly with O-ring. Inspect filter screen for contamination. If contaminated, remove and discard. Fuel pressure ...

Question about 1996 Blazer

1 Answer

where is the fuel pressure regulator located It is mounted under the upper intake manifold. Disconnect the negative battery cable. Relieve the fuel system pressure. Refer to the fuel system relief ...

...awhile, it will turn over but not start. i cant figure out if it is electric or mechanical but wondering how to test the fuel pressure regulator Get a fuel pressure gauge and connect it to the rail ...

i have a 89 fullsize blazer i was on freeway an the truck lost all power burped an started running temp went 2 about 200 got off freewy did compression test #7 has 0 comp.did i blow the rings out ...

Question about 1989 S-10 Blazer

1 Answer

...metal ID tag on one of the bolts..thats the ratio and numbers also...its most likely a DANA with a 4.11 or a 3.86 ratio ..or remove the diff cover and count the teeth on the ring..then on the

Question about 1989 S-10 Blazer

1 Answer

...41 teeth if the ring has 41 and the pinion has 10 divide 41 into 10 = 4.10 so take and divide the higher tooth count and divide by lower tooth count another Example 44 Into 12 = 3.41 Ratio good ...

...i tried again and same thing. any ideas? You may need to add shims to increase pinion gear to ring gear clearance ! Inspect the flywheel ring gear for damage or unusual wear. ?€¢ Shim the ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...