Questions & Answers for: Honda ring count

...ring and gaps to make sure tha sensor is getting the correct count per revolution. Also check for play in the bearing which can cause a fluctuation in readings, especialyy if really loose. Cheers ...

Ad

...with 275,500 failed emission test due to high CO2 emissions. I just replaced the fuel injector o-rings since three of them were leaking. Will this aid in reducing CO2 emission or what else can I

Ad

...blow through the vents, pinholes and jets. Be careful as some have thin / small washers, rubber o-rings and springs; a service manual may come in handy.Good luck and thank you for asking FixYa.

...count the blinks on recored them ring a honda deler and aked them wot the problem is for the amount of blinks you got.if you carnt get to grips with this lift the tank and check the wireing on the ...

... under the riders seat bridge the blank connector turn the bike on then count the blinks one long blink counts as ten then ring your local honda dealer or dobles honda who will help you ...

Question about 2003 CRF 230 F

1 Answer

...count the turns to put it back to factory settings. make sure when you turn it in that you only turn it until it bottoms out dont turn it to hard as you can damage the needle. There is a small washer ...

Question about 1998 VT 1100 C Shadow Spirit

1 Answer

...count the turns so you can put it back to the settings. be careful not to tighten it to tight as you can damage the needle. There is also a o-ring (very small) and a washer also very small in there ...

Question about 1994 Accord

1 Answer

count exactly how many revolutions to take it off, then when you put it back juts recount the revolutions and get it exactly the same. You shouldn't need to get another alignment. The tool you can

...the detergent reservoir so I removed the pump and cleaned it out really good. I also checked the o rings, and they seem to be ok. Also, the small golden bolt on the side of the water outlet was ...

...ring gear before installing the starter? Damaged teeth on the flexplate will cause grinding. Did you put the old starter next to the new starter and compare them? The bendix gear must have the same ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

1992 Honda Accord
1992 Honda Accord

2,998 Questions

1991 Honda Accord
1991 Honda Accord

2,681 Questions

1995 Honda Accord
1995 Honda Accord

1,631 Questions

1996 Honda Accord
1996 Honda Accord

1,636 Questions

1998 Honda Accord
1998 Honda Accord

1,570 Questions

Top Honda Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...