Questions & Answers for: Kenwood right channel Audio Players & Recorders

...right channel put out distorted overdriven audio and the left channel had no audio. I looked inside and the left channel fuse was blown. I replaced the fuse now the right channel has no audio and the ...

Ad

...right channel. Wire both positives and both negatives from both subs to the bridged connections and the output will be 150 watts into 4ohms. Giving each sub 75 watts should make them push a little ...

Ad

Question about 12" 4-Ohm Single-Voice-Coil Subwoofer

1 Answer

...your base completely then you know your amp isn't getting signal from the left channel thus if you move it all the way to the right and the bass disappears then the problem is with the right

Question about 12" 4-Ohm Single-Voice-Coil Subwoofer

1 Answer

...right channel of the rear speakers seems dead. It will not produce a sound. The left channel is fine. I have verified that the speakers and wire are fine, but I don't know what to do next. I really ...

Question about VR-806 Receiver

1 Answer

...right channel speaker. I have swapped speakers around and the spaekers are not the problem. I'm not to tech savy and would like to know if this would this be a major fix (at what cost $) or should I ...

Question about VR-806 Receiver

1 Answer

...right channel ofkr7050 "KENWOOD" KR7050? I presume you have proven the channel is dead by trying multiple sources, swapping a different speaker onto it and that the balance control is NOT all the way ...

...green for left rear and purple/violet for right rear. So you simply hook up the positive and negative wires from each speaker to its corresponding channel based on the speakers position in the

Question about KAC-5204 350 Watt Max Power Stereo Amplifier with Variable LPF

2 Answers

...right channel? If so does it still produce low sound? If you have sub / speakers connected to right channel and then connecting more to left channel, your amp may not have the umph you need to power ...

Question about KAC-5204 350 Watt Max Power Stereo Amplifier with Variable LPF

1 Answer

Wring output on a kenwood power amplifer kac425 Green is left channel Gray is right channel the stripe is positive + for the speakers red is power blue is remote turn on black I ground

...Right now standard 2 channel each sub having their own. I heard doing a series hook up and bridging the subs to the amp would give me a better sound. How would I go about that I'd this is the best ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...