Questions & Answers for: right channel Audio Players & Recorders

Ad

Right Channel Not Working Properly Hello: I have this Mitsubishi HS 421UR that has the following problem with its right audio channel. When the machine is turned on and a tape is played, both channels

Ad

Question about 3000 Watts 2 Channel High Power MOSFET Amplifier Car Audio Amplifier

1 Answer

right channel doesn't work ok the positive post on the right channel quit working and i'm trying to find out what to do to fix it check you rca jacks switch sides if the right channel still has no ...

Ad

...right channel of my AVR I have distortion coming out of my front right channel speaker output and right channel preamp output of my Yamaha reciever (RX-v2600)When I have a external amp hooked up to ...

...is working. Please advise. Recommend changing your FINAL drive AMP IC most house BOTH right and left channels, your drivers right channel input is good cuz it is used to make the left channel ...

Question about TX-SR875 Receiver

1 Answer

...right channel You can try swapping the speakers over to see if the fault goes to the other channel. Remove the speaker leads from the input on the right channel and put them into the left channel ...

Question about RXV-350 Receiver

2 Answers

...RIGHT CHANNEL NOT WORKING The Right front speaker is low in volume. All the other speakers seems to work properly. Please help Adding on again: I have interchanged speakers, if i connect any speaker ...

Question about RXV-350 Receiver

1 Answer

right channel distorted denon UDRA M7 The left channel works fine, the right channel is distorted, above very low level volume. I have switched speakers and cables and the distortion remains on the ...

Right channel is working, but Left channel doesn't. Not speaker problem. on the mixer panel, only the right ch. signal level light is brinking. if this is true on all right channel inputs and not just

Question about Europower PMP3000 12-Channel Powered Mixer

1 Answer

...right channel. If nothing obvious stands out, with the power on, using an insulated screwdriver touch the two channels one at a time. Keep away from the power supply and anything that is common to ...

Right channel out (2 o'clock) Green wire - Right channel ground (4 o'clock) Blue wire- Left channel ground (8 o'clock) Alternately the connection arrangement could be in a vertical line with alternate

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...