...spindle of the ribbon cartridge. Push until the spool clicks onto the spindle. ? Put the empty take-up spool on the spindle with the solid black gear. Push until the spool clicks onto the spindle. 6: ...
Question about 105Se Thermal Printer
...ribbon tense Your supply spindle is "too tight". Procure a "Washer Felt w/lube kit" (Zebra part number 01688-140) and rework the supply spindle. Use only the supplied silicone oil to service the felt ...
...ribbon spindle and slide it on the front ribbon spindle. You then load the new ribbon on the back spindle and attach the ribbon end to the empty plastic ribbon core on the front spindle. You CAN ...
Question about 9403 Thermal Label Printer
problem, but it sounds more like it's the ribbon spindle itself. The spindles contain clutches, and when the clutches bind up the spindles don't want to turn. Sounds like you need a new ribbon spindle
Question about Z6M Plus Thermal Label Printer
...contrast set too high. If it breaks as it feeds under the printhead (while printing) your contrast may be set too high. You also could have a ribbon spindle issue. Are both ribbon spindles
...ribbon take-up pressure needs to be adjusted. Supply Spindle: a pair of set screws near the outermost point on the spindle locks the adjustment in place. Loosen the set screws, then move the center ...
...ribbon drive spindle out of the cassette and leave it free to remove, but sometimes the ribbon can become twisted on to the drive spindle and it won't disengage. If that has happened you will have to ...
...ribbon attached to the take-up spindle, does the take-up spindle still spin? If not, check the belt/pulley inside rear cover of printer. 3. Take-up spindle (and feed spindle, for that matter) have a ...
...ribbon take-up spindle release knob counterclockwise, squeeze the ribbon against the ribbon take-up spindle tension blades. When the tension blades collapse into the ribbon take-up spindle, hold the ...
ribbon but the spindle that receives the ribbon seems to be functioning properly. Right now, the inner part of the spindle will turn but the outer part of the spindle will remain stationary. Therefore
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions