....When cassette is inserted and pushed into mech .The latch for LS chassis wears down ribbon and causing a sensor fault .. T reel fault. Load the tape again, and perform operations from the
ribbon stal 34 RIBBON STALL TIMEOUT Yes In the CT emulation with a coax interface, the ribbon has not moved for 10 minutes after CLEAR was pressed to clear the ribbon drive fault. Reload the ribbon.
...ribbon fault. I'm told by my ribbon supplier that there is an override to keep the ribbon from causing the fault. Can you enlighten me? Thanks, David If the ribbon is causing the Ribbon Fault, they ...
showing Ribbon Fault hiclean the ribbon then if still same error chang the ribbon first replace ribbon then clean ribbon sensor at left side if not check cable to motor of ribbon works properly
Question about 6306 Matrix Printer
...ribbon fault...what are can i do...is it the hardware problem It could be the problem with your Ribbon cartridge, Ribbon motion sensor & Dust contaminated in ribbon mask/Hammer. Replace ...
ribbon fault error The ribbon turns without difficulty. I may get a run or 20 or 200 or sometimes more -- it varies -- before the ribbon fault message appears. I do a clear, then resume the print job.
Question about 42HP66 42 in. LCD Television
ribbon fault, at top of the tv are ribbons connector to the screen, when one is faulty the heat makes them flex causing this fault, you can bond the ribbon down with a bit of rubber to stop it flexing
Question about LN-T4661F 46 in. LCD HDTV
...ribbon fault, there are ribbons attach to the screen at the top there's chips installed on them. when one is faulty they heat up and make the ribbon start to flex and move causing this fault, hope it ...
Question about LN-T4661F 46 in. LCD HDTV
...ribbon cable? Hi John, the fault could be caused by either, you could start by carefully un clicking the ribbon clamps and popping the ribbons out and cleaning both the securing socket and the ...
Question about LN-T4661F 46 in. LCD HDTV
ribbon our fault on markem 2200. Ribon loaded and present. looking for drawings for the location of the sensor . Markem 2200 printer ribbon out fault starts but then faults after a couple of prints ...
Usually answered in minutes!
371 Questions
397 Questions
331 Questions
310 Questions
259 Questions