...clunk when put in reverse i have a 2001 v6 toyota camry and when i put it into gear it clunks....i replaced the top mount and the clunk went away while puting it into drive...now it only makes a dud ...
...i knew what that soudned like. It makes a louder clunk in reverse than when it is put into drive. Make turn left noise will be on right, turn right noise will be on left this is CV joints.Make
reverse the car didn't immediately go backward. There was a brief (5 second) interval and I heard a clunk. I've also heard a sound under the hood. A friend says he thinks I have a belt problem. Anyone
...to reverse or neutral to reverse there is a loud clunk Either the u-joints are bad and that is what is clunking or the tranny fluid and filter need to be changed. usually it is the u-joints that ...
...reverse and at slow speeds. There is a single clunk during the turn, and another single clunk when straightening the wheel. Most likely you have a bad drive axle, each drive axle has 2 universal ...
transmission clunks when putting into reverse when i shift my 2001 ford focus out of park into reverse i have to rev the engine and then it clunks when it shifts, fluid is full in AT. Why do you rev ...
clunking noise from reverse to drive 2006 chevy malibu have clunking noise when i'm in reverse...what is it?
...Is the clunk as soon as you shift into reverse or when you press on the gas peddle? If it is when the peddle is pressed then let off does it clunk again? Does the car shake or lunge when it
...from forward to reverse clunk going from forward to reverse or reverse to forward check transmission oil,normally it should be red,smell it, it's not suppose to smell heated oil,have the clutch
...reverse or drive i get a clunk as if the brakes are grabbing after i am stopped . Tried it in neutral and there is no clunk The drive shaft is engaged when in drive or reverse, U joints connect the ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions