Questions & Answers for: Chevrolet Tracker rev 1 15

Question about 2002 Tracker

1 Answer

...know Gm engines are NOT safe i.e. the valve miss pistons. It sometimes isn't too severe if very low rev's i.e. tickover, usually 2 or 3 exhuaust and same inlet. Let's hope no seats. Cheer's! Paul 'W' ...

Ad

Question about 2000 Tracker

1 Answer

had a bad coil changed coil on no i plug how do i clear code for services eng soon the cheap way is just unhook the battery for about 15 mins then it should be off

Ad

Question about 2000 Tracker

2 Answers

one light is dimmer than the other on a 2003 Chevy Suburban I assume you mean headlights -- is this correct? Could be a lamp going bad or a bad/dirty connection. Check the 15 amp fuses under the hood ...

My 2001 Chevy Tracker quits running after a while and will restart after about 10-15 minutes. It originally runs rough after it restarts. I have been told to replace the camshaft sensor. Also, when I ...

vehicle will not start for 15 t0 20 min.after vehicle will not start for 15 to 20 min.after running for even a short distance. Also will quit if left idling after running a while. It runs fine as long

...and try to rev a little. If the vacuum drops it could be a plugged cat or muffler, some type of exhaust restriction. Vacuum should pull steady at 15 to17 inches at idle. This is just one

my chevrolet tracker is cutting off while driving and I have wait about 15 minutes before it starts next time it stops,just take the fuel cap off briefly,then see if it will restart.removing the ...

I have a 2002 chevy tracker, can I put 215/15 tires on it without doing something to suspension. It's not a ZR2 the correct size is listed on the drivers door jamb. if you put a taller tire on, the ...

Question about 2000 Tracker

1 Answer

2000 Chev Tracker cuts off after running for a while. It does this at slow speed, like in traffic. Also, will not restart after running for a while. After about 15 minutes it will start. I would ...

the instrument panel light fuse blew, replaced it and it blew again, what causes this Possible overloading try to put a different fuse like if you have 15 amp try 20 amp fuse let me know if that solve

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...