Questions & Answers for: Yamaha rev 1 15

Question about 1981 XJ 650

Starts easy wont rev at all

...rev at all yamaha 82 virago 750 Float bowl is spotless floats set at carb body split no holes in diaphram new needles everything clean. Bike starts very easy. wams up fast ( close enricher after 15 ...

Question about 1998 YZF Thunder ace 1000 R

1 Answer

Engine knock at high revs

Engine knock at high revs So, after the engine is well warmed up, say 10-15 miles my trouble starts. From cold there is no problem. Under acceleration and on overrun there is no noise and engine ...

Question about 2002 V-Max

1 Answer

Vmax will start and barely run only under full choke

...rev for 15 sec then repeat process again another 3 times. Ride itnormally as if you are breaking it in until next time refuelling, add another 30ml and do the same process before riding it again. Do ...

Question about 2005 YZF-R1

0 Answer

My r1 stalls after a time riding and stuggles to idle

...rev it over 3000 revs to keep it going Hi, Glen and the usual suspects are: 1. Severely discharged or a damaged battery, should have 12.5 volts or better and be able to pass a load test if necessary. ...

Question about 2003 DT 125 R

0 Answer

My dtr gets hot easly

...gets hot easly how can i stop my dtr 2003 getting hot and overheating cause it looses power bottom revs then starts spluttering after about 15 mile Hi, Anonymous and the usual suspects are: 1. Low ...

Question about 2004 WR 450 F

1 Answer

Hi my wrf450 on tickover revs up and down even when warm , it take for ever to kick up but when warm it starts on the button , thanks sean

hi my wrf450 on tickover revs up and down even when warm , it take for ever to kick up but when warm it starts on the button , thanks sean hi , i have a yamaha wrf 450 2004, ive just put a new plug in

Question about 2004 WR 450 F

0 Answer

Yamaha dtr125 misfire at high revs

yamaha dtr125 misfire at high revs revs up fine on-off but when held on it misfires so u cant ride properly its not like im (valve bouncing) its just weak at top end ive tried new plugs different coil

Question about 1997 YZF 600 R thunder cat

1 Answer

2006 yzf600r when shifting to 2nd get a loud,fast,hard knocking. I can hit the clutch and rev up fast and go to 3rd,or if not the bike will roll about 15 ft and stop then I got to turn the bike off to

...rev up fast and go to 3rd,or if not the bike will roll about 15 ft and stop then I got to turn the bike off to switch out of 2nd gear.all other gears work fine and have replaced clutch,didn't help ...

Question about 2008 Zuma

0 Answer

Yamaha zuma will not rev up. it will only go about 10 to 15 mph. iv cleaned the carb and tuned it in and still there is no rev .

rev up. it will only go about 10 to 15 mph. iv cleaned the carb and tuned it in and still there is no rev . its a moped from 96 to 2000 i dont know the year Hi, Anonymous and the usual suspects are: 1

Question about 2008 Zuma

1 Answer

2008 Grizzly 450. Starts and idles fine but at about 10 mph why does it start to cut out like a rev limiter?

15 posts May 21, 2009 Hitting rev limited/ slow speed.... - Yamaha Grizzly ... 11 posts May 20, 2009 reverse rev limiter - override witch bypass - Yamaha ... 6 posts Oct 22, 2008 More results from www