Questions & Answers for: Chevrolet Blazer reset temperature gauge

gauge not working I changed the battery in my 2004 blazer, and now the temperature gauge doesn't work Maybe a fuse? could be! check it,if ok, check elect.connector at temp. switch unit and unit itself

engine wants to bog down when a/c is engaged, what is the problem to this? Fuel gauge and temperature gauge doesn't work. My fuel pump works and so does my temperature sender. What could be my problem

gauge cluster is out of spec, in other words, it should be accompanied by a low/high engine temperature, a low fuel warning, an oil pressure light, a coolant level light, or something similar. If none

...temperature gauge? If the engine temp is low and there is no heat in the cab, it's most likely a thermostat stuck open. If your engine temperature is good, but no heat in the cab, then it's probably ...

...will bounce to above high and reset to normal yet never over heats or gets hot. it could be a faulty temperature gauge sensor or a loose wire causing a bad connection....hope this

...temperature; you probably have 2 with 1 working the dash gauge and the other controlling the engine setup.  You want the engine to get a signal from the temperature sensor, because it does not ...

...3.TEMP GAUGE WONT WORK The temperature gauge sensor for a 1995 Chevy Lumina is located in the sending unit. -------------------------------------------------------------------------------- PSA BSI ...

...gauge) read the temperature of the liquid in cooling system. From what I understand, the temp gauge jumping around has since gone away after you placed water into the radiator. It is very possible ...

...temperature gauge reads normal and when hooked up to a computer reads -40 and runs rough, clear code runs great for few seconds then service engine soon back on and runs rough. Any suggestions? on a ...

...temperature gauge. sender and sensor are new. still pegged on hot If you replaced everything back to the guage itself, then it has to be the guage itself. I would try getting a replacement instrument ...