Questions & Answers for: Buick Century reset temperature gauge

...gauge not ready true? All tests and signs point to that the cooling system is working. Any advice would be greatly appreciated. Thanks for your time the connector to the temperature sender may not be ...

...temperature gauge sensor (you will need to drain the antifreeze from the radiator (and later replace/reuse it) using the finger-turned draincock at the bottom of the radiator, and should only do this ...

...gauge is not not working and the old motor had a place for a sencer in the front of the motor. is there one on the 2000 3.1? YEP NEED TO HAVE ENGINE COOLANT TEMPERATURE IN PLACE.ENGINE COOLANT ...

The fan never turns on. The temperature gauge is ok. If the sender is disconnected the fan operates at full speed. What has failed? try replacing the sender unit

temperature gauge reading hot but engine is not hot and my heat gets cold when temperature gauge gets high Check your coolant level. Could be a stuck closed thermostat.

temperature gauge bouncing ? 1996 Buick Century Limited, temperature gauge bounces all over the place. The faster the engine revs, the faster the needle bounces. Goes back to normal as soon as you let

...century to overheat? Overheating It sounds like your car has a bad thermostat that won't open all of the way. However it could have a bad electric cooling fan, fan relay, temperature gauge or

...temperature gauge only reach a little past half? new head job, thermostat, radiator, cooling fans and a new water pump Larry, If the cooling system was not bled properly, the temperature could ...

...temperature sensor circuit. ?€¢ The IPC detects a loss of class 2 communications with the PCM. Fuel Gage The IPC displays the fuel level as determined by the PCM. The IPC receives a class 2 message ...

...temperature gauge is still more than half on gauge,i'm worried that it may over heat again. what do you think is the problem and is the only car i use to go to work Blind guess would be the ...