change oil alarm in dodge nitro is flashing after oil change how can i reset It is possibly flashing because there is still too little oil or too much oil.
...turn the key off, after that start the vehicle that should reset the light and alarm. please rate thanks You need to reset it. Look in your owners manuel for instructions to reset oil change
...change oil light how to turn off ... 2008 dodge nitro change oil light how to turn off had oil changed did not go out Directions are in the book, but you would put the key in and turn it all the way, ...
...There is also a mobile app for your phone that has all the oil maintenance light reset procedures from these guys. Hope this
reset oil light 2011 jeep gand cherokee Turn key to on position(do not start). Hit gas pedal completely to floor 3 times. Change oil light should reset. oil maintenance light (oil change nag? or oil ...
...started flashing then I cut it off tried to reset still the light came on. I put the scanner on it and it turned out to be the coil plug on the #3 cylinder. COIL PLUG. Hope this helps out GOD
...Oil is good. I put coolant in. Dont know what else to check or how to clear it Some car parts places like AutoZone will plug in a diagnostic tool called an ODB2 and can tell you the error code. then ...
reset oil change light on citeron nemo 2011 Reset oil light after service... that is very important. And don't skip the oil change either. 1-turn on the ignition key, 2-press the gas pedal and hold it
dodge nitro 2011 does not turn on the stop lamps i had review the fuses, and are in good condition, also changed the lamps, but still the problem Could be a bad brake light switch.
my serpentine belt on 2011 dodge nitro.I can't get to it can you help me thanks Pull Back The Little pulley And Take It Off 2011 Dodge Nitro change serpentine belt YouTube All are pretty much the same
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions
