Questions & Answers for: reset mp390

...Reset procedure Waste Ink Tank for Canon MP390: Start with printer on, press additional functions, Scan, Copy, Scan. Now you should be in service mode. Select Test mode (must be the last available ...

...mp390 Hi, my problem started when i pulled my rint head to clean it. After i replaced it. I got lcd display saying "put in cartridge" so i turned off printer for reset and now lcd displays " check ...

...Reset procedure Waste Ink Tank for Canon MP390: Start with printer on, press additional functions, Scan, Copy, Scan. Now you should be in service mode. Select Test mode (must be the last available ...

...MP390 Printer - error code #345 "waste tank full" alarm; you may need to reset the waste tank counter. Try: Resetting the Waste Ink Volume Counter 1) Enter SERVICE MODE.--- By pressing Menu-Copy-# 2) ...

...reset-waste-ink-tank-canon-mp390-and.html Hi, 1: Unplug power and USB 2: Open door and hold power button. 3: Connect power. 4: Close door, then release power button 5: Connect USB and an press power ...

mp390 inkwell is full how do I perform this maintenance? You have to remove the entire printer engine and replace the ink absorber pad, you have to s, After that you have to go into diagnostic mode to

...Reset procedure Waste Ink Tank for Canon MP390: Start with printer on, press additional functions, Scan, Copy, Scan. Now you should be in service mode. Select Test mode (must be the last available ...

MP390 Printer has come up ''Waste Inn Tank nearly full'' What should I do CANON printers "compute" the "fullness" of the waste-ink container, based on the number of pages printed, and the "density" of

...I replaced both cartridges but the alarm keeps going off stating put in cartridge? i had same problem with 350 you need to google how to reset mp390 and follow instructions it sould be fine ...

reset mp390 mp390-waste-ink-tank-full 1. Press ON, ADDITIONAL FUNCTIONS, SCAN, COPY, SCAN This will enter into Service Mode 2. Select Test Mode, last selection, use + button then press SET 3. Select ...