Questions & Answers for: reset check engine light 97

...And the check engine lite comes on once in awhile indicating an error on the Catalytic. I had the Catalytic changed out but the Check Engine will come back indicating the same error in a few

Ad

AND MY CHECK ENGINE LIGHT IS ON FOR A EVAP CONTROL SYSTEM (LARGE ) I REPLACED THE FUEL CAP AND EVAP SENSOR BUT STILL DOES IT I suggest Reset your ECU, maybe need eraser the fault recording. Hop helped

Ad

Question about 1997 Grand Cherokee

2 Answers

...check engine light on, diagnostic trouble code says, '' error 51** Fuel System Lean A lean air/fuel mixture has been indicated by an abnormally rich correction factor, which sensor is causing this o2 ...

Question about 1997 Grand Cherokee

1 Answer

...97? There were some chrysler transmissions around that year that were year specific, a good wrecking yard can help you, they can look up and see which other years will fit based on your engine size ...

check engine light on,1997 Jeep Grand Cherokee,4.0 six cylinder.code 1757.cleared code,comes back on after a few minutes of driving. Trans is sluggish,when pulling out,after a complete stop. I just ...

Question about 1997 Grand Cherokee

2 Answers

...light, or a ohmmeter and check the wires at the wire plug under the dash that go to the multi-function switch thru the steering column cover, you should have continuity between #18 and #19 low beam ...

97 jeep grand cherokee loses power while driven this can be due to transmission or MAP sensor or cranck position sensor. do you check engine light?

Question about 1996 Grand Cherokee

1 Answer

Engine Immobilser disconnect ZJ -97 locate Engine immobilizer Jeep Grand Cherokee -97 We have information on factory installed system only.

...check engine light one, slight squealing sound? the check enging light came on after driving 30 min on the highway at 75 mph, now there is a slight squealing sound and it shakes slightly when I drive ...

...97 jeep grand Cherokee will startbut then dies,an i cant find egr valve When it start thr engin is wide open First check linkage to see if its sticking if so try spraying the linkage with carb ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...