Question about Fbq3102 Dual 31 Band Equalizer Home Equalizer
Behringer FBQ3102 Channel 1 EQ dead. Signal passes in bypass Where can I get a schematic for this. Any routine causes for this? It couse from defective on one or some fader slider, cleaning it from ...
Question about Xenyx 1002fx Mixer 10 Input 2 Bus with Efx
I have a behringer xenyx 2442 and the main output fader no longer works. Each individual channel fader now seems to go direct to the main mix and appears to bypass the main fader The utput fader has ...
Wah wont always bypass when I let off. The switch has probably failed or the pad that actuates it. These things take a beating. Verify that the switch is mechanically working, and then check with ...
my Behrigner SO400 Unit doesn't bypass the signal!! It only works when the unit is turned on...it makes no sense! Thank you Often the problem is the switch itself is broken internally. Test ...
hum on channel 2. I assume that the hum exists without any cables plugged into the input. If that is not the case, then make sure all input cables and source are using BALANCED lines. If the hum is ...
I have a Behringer PMP 6000 powered mixer. Channels 4 & 5 yellow overload light is constantly lit. No sound from either channel (just a faint hum when volume slider approaches max level setting). ...
inserts how to use properly no signal from inserts using trs cable to e/q send return . bypass works though, Not sure what lead you are using, from the mixer end T R S are send return and screen ...
output distortion from bass amp amp was working fine then plugged it in turned it on and everything was working except the output sound was distorted ,have tested other speakers on the amp and same ...
Question about USA FBQ2496 Ultra Fast 24 Bit 96 kHz Feedback Suppressor Parametric EQ
...pressing and holding the "Reset" and "Bypass" buttons, simultaneously during power on. It worked after 3 or 4 tries. "Bypass" buttons, simultaneously during power on. It worked after 3 or 4
Question about USA FBQ2496 Ultra Fast 24 Bit 96 kHz Feedback Suppressor Parametric EQ
1 speakon connection on my Behringer pmp1000 has no audio,however,all lights indicate both chnl ok Anyway to bypass the speakon connection and end up with 2 working spkers? you should replace/repair ...
Usually answered in minutes!
147 Questions
75 Questions
19 Questions
14 Questions