Questions & Answers for: SMC reset button

reset button for a minute and while you are holding the button, also unplug the power cable from the back every 15 seconds. So, you would unplug the power 3 times and make sure, dont release the reset

Reset button on the rear panel of the router. Use a sharp object like a pen or a paper clip to press and hold the default reset button for about 20 seconds, until the test light on the front turns on.

...RESET button on the Router. It is found on the rear panel (except 7004ABR/7008ABR, where it is found in the front). It's a small pinhole blue button. Use a paperclip / pen / pencil to hold in. Reset ...

...reset button for 10 -20 sec. Then you can login to the router using username 'smcadmin', password - 'admin' or 'blank'. Thanks & Regards, Prema. Lost windows password is not a big problem. I ...

where is reset button located, please. Hi, The reset button is at the backside of the box ( near to the wireless antenna). That tiny black button more over looks like a black dot. Best Regards

...Reset button for 20-25 seconds and the power up with all cables attached but be prepared that all the previous settings will be lost and the router shall be reset to factory defaults hope could be of ...

...reset button.There is a very small button on the back of your router get a pen and click on it and hold for 10 seconds and it will reset your router.(remember to have power on) Linksys IP number is ...

...RESET button on the Router. It is found on the rear panel (except 7004ABR/7008ABR, where it is found in the front). It's a small pinhole blue button. Use a paperclip / pen / pencil to hold in. Reset ...

reset tried resetting with button at rear, but refuses to reset. Power-on the router. Push the button, and hold for ten seconds. Power-off the router. Push the button, and hold for ten seconds. One of

reset button on it mainly on the back of it To hard reset the router, you need to unplug all the cables from the back of your SMC router, except its power cable. While the router is ON, press and hold