Questions & Answers for: Honda CR-V is there a reset botton

maitenance required light is on Change the oil & filter. To reset light perform following. With instrument cluster reading odometer turn key off press & hold the reset button turn key to run position ...

...an oil change, it reads A 1, then a -893km that keeps going up? What does this mean? You need to reset you oil life. Cycle through til your oil life shows up. hold reset for approx. 10 seconds or ...

...my 2005 honda C.R.V. It has been serviced today by independant garage. They must have forgotten to reset the light. If you take a look in the service manual it should tell you how to reset it. With ...

...take the CR-V to a shop that deals and is certified with A.C and have them Test your system. To reset maintenance light, first you need to reset trip A to zero (0) and reset trip B to zero (0) ...

...reset trip botton for your miles and while holdin down the botton turn the car on but dont start it just leave it in acc mode hold the botton for about a min the turn the car on you might hace to do ...

how do I RESET MY OIL GAUGE TO GO BACK TO 100%? I HAVE TURNED THE CAR TO THE ON POSITION, I THEN GET IT TO WHERE IT SAY 30%, I THEN PRESS THE BUTTON TIL IT FLASHES "cancel" i then let go, then press ...

How do I disengage the antitheft because I lost my botton device but still have my Key. Every time I try to start it the alarm goesoff With all the alarms ive had u have to unlock the car with the key

I cannot reset the maintenance minder With the key in the off position, press and hold the mileage reset button with your left hand. Turn the key to the "on" position and watch the maintenance light. ...

97 CRV, Check engine light is on steady at idle, but blinks at road speed. Shows only a random misfire code,(ONE CODE ONLY) but misfire goes away at 1200 to 1400 rpm. Have replaced ...

2002 honda cr v select/reset button broken The select/reset button no longer cycles through the trip meter (total/trip a/trip b). Trip meter is stuck on trip b. Also, when attempting to reset Maint ...