Questions & Answers for: Ricoh is there a reset botton

...hold the red clear/stop botton for three seconds. The screen will change and then turn the copier off. this should reset the code.. That is if there was a power problem. Try it and see what

...botton ( Reset/ CA), then 1 then 0 then7 , then hold down the (Stop) botton till the display changes... Then turn the copier "OFF" then "ON" it may clear the code. The code has to do with your fixing ...

...reset it by turning the copier "ON" and once you have the code displayed on the screen.... Press the Yellow clear botton once - then the #'s 1 - 0 - 7, one at a time then press the Red Stop botton ...

...reset the code... Clear yellow botton 1 0 7 then press and hold the red stop botton till the display changes and then turn the main Power switch Off then back ON... You do not have to do any thing in ...

reset procedure that is done through operation panel: press "Clear Modes" botton,then 107,then press and hold the "Stop" key for 3-5 seconds until you see the screen has changed.After that you need to

reset procedure that is done through operation panel: press "Clear Modes" botton,then 107,then press and hold the "Stop" key for 3-5 seconds until you see the screen has changed.After that you need to

...reset by pressing the "Yellow" Clear botton then the numbers "1""0""7" then press and hold the "Red" Stop botton till the display changes. Then turn the Main Power switch Off and then back On. If it ...

...botton till the screen changes. Once it changes turn the main power switch off and then back On..... If it is not cleared you may have a problem with the fuser unit.... Good Luck my name is Gidibyte: ...

..., KEY 0 , KEY 7 & HOLD THE YELLOW KEY FOR SEVERAL SECONDS, THEN THE MACHINE WILL ENTER SP MODE reset-806182-clear ...

...it still reoccurs. Possible bad thermistor or power supply board. To go to service mode press up and down botton for about 5 sec and then press enter. In service mode engine fuser reset SP5810 ...