Questions & Answers for: Ford Mustang reservoir

Question about 2007 Mustang GT California Special Convertible

1 Answer

...to go down & it works fine. You are probably low on fluid. Behind the rear seat is your motor/pump/reservoir combination. With the top down, fill the reservoir to overflowing with ATF. Cycle the ...

Ad

have oil in my radiator fluid reservoir tank (1996 v6 3.8) oil in my radiator fluid reservoir tank Twice in two years now my Saab 9-5 has had a pin-hole in the oil cooler, which has caused oil to flow

Ad

...sure how to fix this. Help! You are probably low on fluid. Behind the rear seat is your motor/pump/reservoir combination. With the top down, fill the reservoir to overflowing with ATF. Cycle the ...

...the vacuum source on the engine to the heater control head. defrost is fail safe mode. A/C Vacuum Reservoir Tank and Bracket Removal and Installation Open the glove compartment (06010) . Working ...

...up with us pulling on it. You are probably low on fluid. Behind the rear seat is the motor/pump/reservoir. With the top down, fill the reservoir till it overflows with ATF. Cycle the system a few ...

...them all. If you have a bad piston, replace them both. The pump (Behind the rear bacrest) has a reservoir on one end. The reservoir has a rubber plug on the side. Remove the plug and fill the ...

Question about 2008 Mustang

1 Answer

...that is not relevant to the problem. The hose can be pulled easily from underneath of that washer reservoir. First thing is to find out why the washer fluid leaks, look for the cause of the leak.

...do i check fluid for convertable top "How do I get the air out of my hydraulic system"?Remove the reservoir plug on the motor pump. Leave the plug out and do not put back until you have finished. ...

...should notice a brake fluid leak as poor braking as more and more leaks out-check the brake fluid reservoir. You almost never need to add brake fluid, a sealed system, so if fluid is low, check for ...

Question about 2000 Mustang

1 Answer

...How do I do that? With most Fords the screen wash motor is mounted on the bottom of the fluid reservoir, it is just pushed into the sealing ring. So just unplug the wires, twist and pull the ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

1998 Ford Mustang
1998 Ford Mustang

706 Questions

2000 Ford Mustang
2000 Ford Mustang

694 Questions

2001 Ford Mustang
2001 Ford Mustang

653 Questions

1995 Ford Mustang
1995 Ford Mustang

589 Questions

2002 Ford Mustang
2002 Ford Mustang

617 Questions

Manuals & User Guides

Loading...