Questions & Answers for: Saturn SL replacing rear brake pads 1999

...brake shoes & pads are new & so are the drumbrakes.the mechanic already adjusted the rear brakes but problem stll exist Sounds like air in the fluid or low fluid level. Check the brake fluid level ...

...rear pads and driums on my car yesterday I took it for a run and when I hit the brakes I have a horrible knocking noise on both sides. I cleaned and greased all the points, adjusted them so that the ...

...replacing.... estimated over $500 repair just for the rear brakes. When I dropped the car off yesterday I'd had the mechanic visually inspect the front tires with me and we both agreed they needed ...

...rear drum. They should be drum brakes. Are you going to be replacing the brakes? I would be very careful with how you go about this. I had a Saturn in high school and I had to replace the rear drum ...

...rear brake lights or turn signals/hazards. The fuses all are fine. What could cause this issue? replace the brake light switch. its on top of the brake pedal bracket. it may of just fallen out of its ...

...rear brake light housings? are you sure the bulb is good?? my '99 SL1 had the same problem, neither lower brake light would come on but the tail lights worked just fine. And it's the same bulb. I ...

brake pads they need to be replaced also. If the pads spent any kind of time against bad rotors they are garbage.When it is time to put the new brake pads on the saturn open the master cylinder so the

...rear drum brakes!?!?!!?!? These are replaceable hub units as opposed to a bearing which you have to press in and out. You can buy two new hub units on ebay for about a hundred bucks. Take the drums ...

...rear brake shoes but.....spin the rear wheels first is u get the feeling of the shoes grabbing then releasing ( the tire gets loose then tight as u rotate it) u will need to have the drums cut on a ...

...rear wheel after replacing pads & brake hardware make sure the star wheel brake adjuster at the bottom of the drum is turned all the way in, and make sure the slave cylinder at the top is about ...