how to change my rear brake light open up the back panel and it was metal and no opening for the light bulb. You have to unscrew the housing, the plastic housing from the car to change the bulb.
...rear brakes on my 2000 Chrysler Concorde 2.7L V6 DOHC--removed the caliper and brake pads but not sure how to remove the rotor? Can anyone help? If the caliper is loose after taking off the caliper ...
Question about 1999 Concorde
rear seat (lift to release the corner clips on each side holding the cushion to the floor). Then remove the fasteners for the seat belts, then lift the seat back to raise and release it from its clips
...a weird noise in the back Could be brakes pads/shoes are worn out, brake drum/rotor grinding from metal to metal contact. Or a bad brake caliper. Parking brake could be on. Or rear wheel
...brake pipes are closing up inside ,very badly worn lower track control arm bushes or the ma ster cylinder but it depends if its a tandem front and rear or tandem one front and one rear ,another cause ...
rear drivers 3rd front passenger 4th drivers front never pump the brake pedal numerious times while bleeding. push brake pedaldown with engine running open bleeder ,close bleeder let pedal up ,push it
...rear brake shoes may be worn out or are not held together with the springs (a spring may have broken). Have the brakes checked as soon as possible for broken or worn parts. Good luck on this repair. ...
Front brakes are dragging Replace brake hoses.
Question about 2000 Concorde
brake pads on the front and now i dont have a full pedel of brake.The abs light and traction light are both on will the abs cause this problem how much brake fluid did you remove or put brake shoes on
Usually answered in minutes!
Step 2: Please assign your manual to a product: