Questions & Answers for: replacing rear blinker bulb 2010

Replace blown out bulb in 98 Avenger How to replace rear bulb in the back of a 98 Dodge Avenger lol. u have to take the hole tail light out . find the wing nuts in the trunk and away you go.

...rear one works fine. The dash indicator flashes really quick now too. usually this is because of a blown bulb, replace the front passenger bulb and tell me if it helps. replace bulb Hello, this would ...

...rear blinker does'nt blink Your right rear turn signal bulb is blown.Replace the bulb and the fast blinking will stop. Check all four of the turn signal lights. Usually one of the bulbs is bad. ...

2010 avenger and I can't remove the passenger side tailite assembly I am trying to change light bulbs on my dodge avenger 2010 but I can't get the assembly off the car, can you show me the

...rear blinker won't blink and the front light blinks twice as fast. The passenger side is operating normally. I think the bulb is still good, they look good... Any ideas what I need to do to fix ...

2010 Dodge Avenger Fog lights won't work when I turn the multiswitch on, the dash light indicates they are on, but no lights fuse or chang the head light bulb

...rear lamp assembly, you open the trunk, pull trunk liner back a little from lamp assembly, remove two wing-nuts, pull on the lamp assembly and push on the wing nut studs to remove lamp assembly. The ...

rear cause ya may not have to remove any screws on headlight assembly's ya have to get to the back where the wires hook up and twist the socket to get to the bulb same on tail lights but ya have to go

replacing front head lamp. found empty light bulb housing both sides with plugs. has plug for these lamp but no lamps on both sides. all blinkers work but the blinker light blinks fasts. are there two

...blown on that side check rear blinker bulb Check your flasher can.Are all your other lights working at rear Most likely is a dual element bulb, one cannot work while the other one does, check the ...