Questions & Answers for: GMC Jimmy replacing keys

Ignition key The ignition key won't go all the way in. key cylinder pin that holds it in is stuck replace key cylinder they will give you new key along with this No key for a 2000 gmc k2500 I know how

Key won't come out No buttons to push to get key out so you park it and key turns to shut engine off but won't release to remove it. u got 2 use a small screw driver right under key ther is a hole put

no key 2000 gmc k 2500 No key how to replace cylinder wih NO KEY !!! If you just need a key the dealer could make you one with the serial number and proof of ownership. If not you have to drill out ...

Key Stuck I turned off my 1997 Jimmy and the ignition would not turn to the position that allows you to remove the key. It turned off the motor but wouldn't turn far enough to release the key. I ...

Key stuck in on position on 94 Jimmy Key was a little stiff turning on. Wouldn't shift, so went to turn the key off and would only turn towards start again, played with the key and the shift, and ...

with all controls off it blows hot air even on the coldest setting try this relearn procedure. turn key on engine not running set controlls to: vent, tempature cold, fan on low turn key off disconnect

What do I do when the key gets stuck in the ignition When I turn the key back to turn the vehickle off it gets stuck and will not go all the way back. Sometimes it will and i can take the key out, but

key wont come out of ignition Sounds like you may have a bad ignition lock which will need to be replaced. If you manage to get the key out this will happen again and I've been there and it will drive

the battery died in my jimmy and the key locked in, not knowing that it would do this i tried to force it back to get the key out. after charging the battery i got the key out now when i put the key ...

keys stuck in the on position and no power i put the key in the ignition turned it and had no power what so ever and now the key will not roll back and is stuck in the chamber I had the same problem ...