...glove box with some noise I turned off the AC and pulled over I from that point had no smoke or noise but I also had no AC Fan Heat or Defrost no Venting Fan I think this is a Burned up Blower moter ...
...replacing. More info, let me know. Charlie well it's only one fan.. but in hiogh position you feed 12 volts to it.. for lower speeds you use a module or resistor to reduce the speed of the motor by ...
...glove box first. This is reasonably simple and involves a couple of screws, the rubber glove box limit pads, and a 10mm nut. The air filter is located in the heater assembly directly behind the glove ...
...replacing the resistor should help.To locate the resistor open your glove box and roll it all the down take off the panel in behind the resistor will be top right hand side.This should ...
how to replace coolant sensor Hello and thank you for using Fixya. To replace the coolant sensor in your 2004 Hyundai Santa Fe, follow these steps below: Find the coolant temperature sensor in the ...
...the cabin air filter on my 2003 Hyundai 2.7 V6, Can you help? On the 2003 Santa Fe the filter is located in the air box behine the glove box. You'll have to remove the glove box to get to
...glove box with some noise I turned off the AC and pulled over I from that point had no smoke or noise but I also had no AC Fan Heat or Defrost no Venting Fan I think this is a Burned up Blower moter ...
How do you replace the cabin air filter http://alldatapro.com/alldata/PRO~V247750963~C40368~R0~OD~N/0/101825161/106012507/106012508/110695770/34853741/3486 may have to remove the glove box..
Question about 2004 Santa Fe
normal. Any ideas There is a blower control resistor (manual system) or a blower transistor (automatic temp system) located behind the glove compartment in the HVAC box and this is a high failure item
Usually answered in minutes!
1,503 Questions
1,043 Questions
1,001 Questions
881 Questions
417 Questions