Questions & Answers for: Chevrolet Suburban replacing ecm

1997 Checy Suburban k1500....front heater blower issue. it turns on normally, but very little air comes out from the vents... this happens for all settings(defrost, feet, front). if I have to replace ...

Ad

Question about 1987 Suburban

1 Answer

no power to fuel pump ...new pump and relay. ecm fuse was blown also...1987 chev suburban 5.7 eng 4wd Replace plug that comes from car into fuel pump on top of fuel tank. Just cut and splice it in $20

Ad

engine quit on the road had new engine put in still willnot start seems to be off time but assured timming is set correctly replaced ecm still no help please help If it has a coil pack the timing is ...

Question about 1996 Suburban

1 Answer

i have a 96 5.7 chevy suburban died no spark replaced the module and coil crankshaft sensor still wont start getting fuel and no communication from the computer thanks for any help check ecm fuse..not

Question about 1996 Suburban

1 Answer

MY 96 SUBURBAN 2500 7.4L SUDDENLY DIED WHILE DRIVING. AFTER I COASTED TO A STOP I TRIED TO RESTARTING BUT NO LUCK. HAVING HAD THE FUEL PUMP REPLACED BEFORE I KNEW TO LISTEN FOR THAT SOUND OF THE PUMP ...

Question about 1987 Suburban

2 Answers

Check engine light on but no codes In my 1987 Suburban with a 454 and EFI the check engine light comes on once in a while. It always seems to be when I'm climbing a mild grade and only after a

Question about 1997 Suburban

1 Answer

...ECM. You will to have shop plug in the diagnostic code reader to find the failed part or just start replacing parts and hope you find it. First thing I would try is disconnecting the battery for 30 ...

How do I reset fuel shut off on 2002 Chevy suburban their is no reset / inertia switch on suburban only fuses and relays ---will need to test fuses relays wiring connections and or pump for where ...

replacing parts does not cut it . The body control module (BCM) monitors the signal circuit of the cruise control switches. The BCM relays the cruise control switch status to the engine control module

I have 2007 surbarban the engine went out replace it with a 2010surburban but when I hook up the code reader it won't read do I have to change the ecm to a 2010 no...check your fuses The ECM and ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...