Question about 1987 Camaro
Runs good with ecm un-plugged in, but when plugged in runs rough Ive replaced, plugs, wires, got a new comp, with a new prom, fuel pump, all those were bad before, but now i cant seem to get it timed ...
92 camaro fan problem the fan quite working on my camaro, I jumped it to the battery and it still works,...i changed the sensor next the thermostat, the relay, and the fuse is good,...so if the ecm is
I have a 2000 Pontiac Grand AM SE with a V6 3.4 liter engine. I had my check engine light come on and went to Auto Zone to get a code which related to a emission vapor leak. So I took car to my ...
How to change a engine control computer on a 1988 Cameron 2.8 v6 disconnect battery ecm under dash passengers side.remove computor(ecm) there is a little trap door remove it.there is a chip in it that
injectors not opening or "flashing" on 1989 camaro injectors not opening or "flashing" on 1989 camaro iroc-z tpi 305 manual. checked grounds to ecm all are good and engine ground. have new ...
1991 camaro rs, 305, TBI, I INJECTOR DRIVERS SIDE NOT WORKING. REPLACED WITH NEW INJECTOR STILL NOT WORKING. CAR DOES START AND RUN. Hello....The ECM on your camaro has one (1) injector driver in it. ...
car stalls out at 2000 loose power from ecm/pcm car stalls out at 2000 loose power from ecm/pcm to ignition module at 2000 rpm making the car stall out replace ecm the ecm is shot
REPLACE ECM LOCATION OF ECM PASSENGER SIDE FIREWALL
Question about 1992 Camaro
car starts will not accelerate, code reader says Code DTC 22 Throttle Position Low all rdy replace Ignition Starter Switch, and Throttle Position Sensor. this did not fix the problem Well code 22 ...
I have a 1993 camaro z28 that will not rev over 3000 rpms In any gear. It acts like I hit a rev limiter. I have replaced the tps, plugs, wires, icm, coil and distributor. And it does that same thing. ...
Usually answered in minutes!
737 Questions
576 Questions
468 Questions
391 Questions
331 Questions