Engine cranks but won't start. Fuel pump isn't turning on the on position and no spark going out of distributor. could it be a wiring problem or is my ecm bad? Check the fuel pumps operational value ...
94 wagon check engine light on i have the code tool but cant pull code out could it be a short or the ecm bad i smelld something burring like wires looked in engine capartment touch almost ever wire ...
i have a 1994 ford ranger that is blowing the fuse under the hood that goes to the ecm Check for frayed or broken wires comeing from ecm if none replace ecm. make sure ecm ground wire is intact. (ECM ...
my 97 ford f150 is loafing an when i put on a diagnostics test its reading out 02 sensors an i change all four and i also change the massive airflow sensor, and i also had the fuel system cleaned and ...
Question about 2001 Taurus
...replacing battery more likely erase ECM memory.best to start vechicle let enginet idle until ECM relearn memory.your vechicle has to complete full drive cycle before ECM MEMORY return if not let ...
replaced ecm in my 95 f259 5.8, and now it won't shift I had a problem with it starting and dying, changed ignition module, distributor and coil, but still had same problem. Replaced the ECM and ...
Error code P0351 and P0353 New coil doesnt cure the problem could be a ecm issue. if you pulled this code and replaced the coil, most likely it is resistance from the ecm to the coil. its either going
Question about 1994 Ranger Supercab
4x4 4.0l V6. What are the probable causes of DTCs P0112, P0117, P0122, P0513, P0556, and P0565? replaced coil, fuel pump, plugs, and wires code p 0112 refers to intake air temp (IAT) sensor --circuit ...
Question about 1994 Ranger Supercab
I own a 1987 Ford Ranger 2.9 V6 4WD. The fuel and ignition system is basically has all been replaced. A lot of other sensors and the ECM have all been replaced. I sometimes lose all power at times. ...
Question about 1999 Taurus
...ECM needs replacing or try doing hard reset? I checked my fuses, all good. There is no burnt transmissions fluid smell. I just need to know if I need replacement TCM or ECM. Thanks. Question edited ...
Usually answered in minutes!
3,749 Questions
2,998 Questions
2,612 Questions
2,347 Questions
2,636 Questions