Questions & Answers for: Chrysler replacing ecm

Engin Control Module (ECM) My ECM is bad again (4th time) is this something i can purchase and replace myself or do I need to take it in..... It should be something you can do yourself. Most pcm's are

ecm I have a 2000 chrysler sebring conv and I removed the ecm and had it tested because car would not accelerate over a certain speed and sometime would cut off and so I had the ecm checked and they ...

1998 town and country. Installed a new compter now engine turns over but no start and run. Hello If it ran before the ecm switch then its the new ecm. If the ecm was replaced because it would not run ...

engine light diagnosed as ECM. What is your thought. OK, if this is the case. i recommend inspecting the main ECM wiring harness for worn connectors and torn wire coverings. If the wiring harness is ...

multiple engine codes 2001 chry town and country engine barely runs it surges, spits and sputters the main codes are po601 and po206 P0601 : ECM internal Failure. it said that the ECM is unable to ...

how to replace the ECM on a 2005 crysler pacifica see the procedure and fix it. God bless you 1 Open the engine compartment to access the battery. Disconnect the battery with a socket wrench. 2 Locate

I have a 2001 Chrysler T/C 3.8 won,t start have fault codes P0353,P0352,P0351,Replaced coil still no start can anyone help me? codes p351-2-3 refer to ignition coil A -B -C primary /secondary-circuit ...

p0685 fault code uk ford ignition coil was burned, replace it and don't start engine. then change a fuse and engine start but in 3 minutes ignition coil was burned againe p0685 refers to ECM power ...

how to replace a ecm my car stopped in the middle of the street. I took it to the repair shop and I believe it could be the ECM? Only because I had a dianostic a month ago and that was one problem ...

...ECM fuses, if the fuses are OK try replacing the ASD relay. P0688 CHRYSLER - Auto Shutdown Relay Control Circuit Low The Front Control Module (FCM) has detected the supply voltage below an acceptable ...