replace. just take the belt loose. unbolt the water pump and pull it out. scrape whatever pieces of the old gasket are on the block off. and install new water pump and gasket. the put the belt back on
...water pump pulley - you're back no the begenning point idler pulley. Obviously threaded side of the serpentine must sit on threaded faced pulley and flat side of the serpentine must sit on flat faced ...
...water pump fixing the leak however heater was still not working. I have replaced thermostat and checked that the blend doors that are on top and bottom of heater core are working properly...I think i ...
IN TANK FUEL PUMP MODULE STILL HAVING SAME PROBLEM Just a suggestions but... Check fuel filter. Also add some fuel conditioner (e.g. HEAT for diesel) to get rid of any water that may be in your system
replace water pump on 92 dodge ram 2500, 5.9 diesel turbo cummings Disconnect the negative battery cable. Drain the coolant. Use a 3 / 8 in. drive breaker bar to lift the belt tensioner and remove the
water pump in my 2004 dodge diesel 2500 truck!!1 this way I know that i am doing it right!!! Simplest water pump ever made. Simply remove the air filter housing from the engine. Should be 2 bolts that
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions