Questions & Answers for: Ford ZX2 replace vct solenoid

...solenoid on the right side of the shifter, if you take the center console out you can see it, you can zip tie it open and it will fix the problem, i wouldn't bother with replacing it, the only thing ...

I HAVE A 98 ZX2. I CHANGED A VALVE COVER GASKET AND 2 DAYS LATER THE CAR WOULD RUN FINE AND THEN SHUT OFF WHEN TRING TO STOP. IT WOULD START RIGHT BACK UP BUT HAD TO KEEP THE RPMS UP. 2 DAYS LATER THE

replace this solenoid or defeat it with a zip-tie. pop off the little button covering the hole on the console just to the right of the gearshift lever and put a philips screwdriver down the hole. This

...the VCT solenoid is plugged in (sticks out of the top left of the valve cover) and have it scanned again to see if you got any new codes like P138x. P0340- Camshaft Position Sensor Circuit ...

zx2fast had great instructions on replacing the timeing belt when mine broke but now it idles ruf but it runs pretty good open road.... what can be the problem????? You may need to reset the VCT ...

My 2003 ZX2 wont release with the button on the shift lever. The brake lights work,and I can bypass by using a screw driver in the hole on the console . check fuses, remove console and check for power

service engine light came on the code is P1751. where is shift selenoid located on 2003 ford zx2 All of the shift solenoids are located inside the transmission attached to the hydraulic control valve ...

what could be the problem of not getting it out of park it took me 30 mins to get it out of park Depending on what you had to do to get out of park, it could be the brake light switch or the solenoid ...

my car goes forward in reverse why? i have a 2002 ford escort zx2 i just changed my shift solenoids for 2/3 and 3/4 and i put everything back in so when i started my car i put it in reverse to back ...

Why is my Ford ZX2 cam breaking upon install after VCT replacement? when I try to put it in after replacing the VCT? I had it together once without assembly lube but took it apart to put the lube on. ...