1985 k10 ignition - truck will not start I have similar problem. I too have replaced my ignition switch. I have good batt/starter. I power to my solenoid on my starter never gets 12volts. I've traced ...
...away from you. Replace the solenoid, or just put a rebuilt starter while you are pulling it out anyway. There is not a huge cost difference, and you will they have a warranty on the whole
...g van series sounds like the solenoids in the transmission are unresponsive, check the wiring or replace ...
...you put it right back in park then it idles and rev's just fine. what would cause this? Bad lock-up solenoid (TCC) in trans you have a timing problem check it you may need to replace your timing ...
...system circuit wiring and connectors, repair as required * With a warm engine, test the operation of the OCV, replace/repair as needed Hope this helps to solve it (remember to rate this
...replace the vapor canister and selenoid and this will solve my issues? P0449 - Evaporative Emission (EVAP) Vent Solenoid Control Circuit P0455 - Evaporative Emission (EVAP) System Leak Detected Many ...
...REPLACE the PVH solenoid;TEST the system for normal operation. E17 CHECK CIRCUITS 599 (PK/LG) AND 77 (DB/Y) FOR SHORTS TO GROUND PVH Solenoid C185 GEM C223 Measure the resistance between PVH solenoid ...
Question about 1986 Chevy
350 automatic tranny rebuilt,will go forward but can not find reverse the valves (solenoids) for the reverse operation of bands and clutch packs are not getting the message . Check for correct ...
Where is my vent valve solenoid on my 2006 Chevy Colbalt? It's located under the vehicle back behind the fuel tank , Installed in the canister ! Remove the EVAP canister vent solenoid valve from the ...
Question about 1986 Chevy
1995 Chevy Cavalier 2.2. where does the shift solenoid install in the transmission? I took the transmission pan off, and looked there but nothing. THESE SOLENOIDS ARE IN THE TRANSMISSION. REMOVE THE ...
Usually answered in minutes!
363 Questions
210 Questions
125 Questions
