Questions & Answers for: Jeep Wrangler replace tps

...the code number and definition written down.If it were TPS again,the sensor itself would need to be replaced unless the cost was prohibitive,or the wires to and from the sensor and PCM (vehicle ...

i have a 2004 jeep wrangler that is throwing a p0123 tps volts high code i have replaced the sensor and it is still coding. and ideas thanks did you rest the code after replaceing the snsor?

where do I plug in the OBD2 sensor to pull engine codes?? we just has the TPS replaced and the pigtsail checked. We borrowed an OBD2 to try to see if we can check ourselved, but can not find where the

...light won't go off. Analysus says CHECK ENGINE light won't go off. Analysus says TPS but have replaced TPS Twice, Disconnected Neg on Battery for reset and light still comes on . Says TPS. What ...

replace TPS and re-check. 4. If you have no TPS signal, check for 5 Volt reference at the connector. If it's present, check the ground circuit for open or shorts. 5. Make sure the signal circuit isn't

I need to set the tps The throttle position sensor on a Jeep Wrangler is not serviceable.  It must be replaced if bad.

...into the cylinders...running eye burning rich...runs smooth when driving...ruff idle...I just replaced intake gasket cause there pretty much wasn't one...replaced most vaccum lines and ...

1990 wrangler with a 4cyl was dying at idle found the vac line to the map sensor had a crack replaced it and reset the computer. Still dies at idle and now cuts out at higher rpm. Have to fan clutch ...

...cut. already checked vaccum leaks Fuel pressure Compression Plugs-good no sign of lean condition replaced upstream 02 sensor replaced MAP sensor replaced TPS replaced IAC New converter It has a

I have a 1999 Jeep Wrangler 2.5L. I just replaced the TPS about 2 months ago. A few days ago, it started idling really high again. This was after it sat in the driveway in the rain.I took it to ...