Questions & Answers for: Jeep Grand Cherokee replace tps

...would not go faster. After I slowed down the car was working fine, but it happens on and off. replace fuel pump inside tank Has anyone answered you yet on this? tps sensor tps sensor tps

...replace the tps on and it work fine for a week, started messing up again it idles fine, but when i give it gas and let off it dies. Got the same tps code (P0121) again take it to auto zone have them ...

Replaced TPS sensor 4 times in 3 months, still runs like s....... I have a 2001 Jeep Grand Cherokee Laredo with a 4.0. We have replaced the TPS sensor 4 times in the last three months. We hook the ...

...coolant in the bulkhead connector, the likely cause would be a leaking coolant pump. Pump should be replaced if found leaking. If the code sets when the A/C is turned on go right to the bulk head ...

replace TPS and re-check. 4. If you have no TPS signal, check for 5 Volt reference at the connector. If it's present, check the ground circuit for open or shorts. 5. Make sure the signal circuit isn't

Replaced TPS sensor on 95Jeep GrCherokee, had an intermitant Over drive issues(not going into OD). Transmiission was checked out and pressure tested. Found a test using the OD switch and cycling key ...

...tps, transmission shift issues, bucking, jerking, idle surging, engine cut off, hesitation on take off, surge while cruising down highway. have a good one!! most often the check engine light will be ...

...replace TPS and re-check. 4. If you have no TPS signal, check for 5 Volt reference at the connector. If it's present, check the ground circuit for open or shorts. 5. Make sure the signal circuit ...

...replace the TPS and one person said TCM what is the difference. Surges RPMs and feels like it is powering down when it does. The TPS ( THOTTLE POSITION SENSOR) tells the engine computer and trans how ...

...replace the TPS. no engine option stated, and is key fact to know here. eg: The 5.7L V8 engine does not use a separate Throttle Position Sensor (TPS) on the throttle body. remove old TPS, and bolt on ...