Questions & Answers for: replace tine shaft pony tiller

...replace the wheel shaft seals on the left side of tiller. My question; Is it possible to remove the old seal and replace it with a new one without taking the transmission apart? If the seal fits over ...

shaft. This will now allow you to swing the idler out of the way so the belts can be removed. A little twisting and turning and they will come out and go back in without a problem. Reconnect the idler

...tine assembly fell off shaft....after replacing broken bolt left side tine assembly wobbles...help sounds like the shaft is either bent,or the inside diameter is worn and the shaft tube needs to be ...

Replace tine shaft oil seals - Junior model How do I remove the tine shaft oil seals on a Troy-Bilt Junior V (Mod # 15006, S/N M0104189)? The outside of the tine drive housing has a silver-colored ...

...shaft to change reverse disk? A friend gave me an older model Troy Built tiller and I am trying to replace the reverse wheel. I have some experience working on machines and am looking for hints to ...

Tine Tiller. I need to replace the dry rotted tires. I easily removed one tire. The other tire moves somewhat, but I cannot get it off the shaft. How do I remove it so I can replace the tire/rim? Help

...replace the seals on my Troy-Built Pony tiller. 6 hp, ser.# 121811201149. I can not seem to remove the tine shafts. I have pulled the bolt thru the shaft but cannot budge it. Does anyone know what I ...

...have a thick oil put in it to stop the engine rusting if stored for a long time this needs to be replaced before starting the engine. if the engine oil is dark and very thick this may be the case ...

...tiller. The shaft and wheels are moving back and forth from the gear box. The "Slow and Fast" lever is also not engaging. What can I do? The serial # is CH-1001 / 337-Y. Any help would be greatly ...

...replace your seals. On the Horse model you remove the wheels and then carefully use a couple of screw drivers to pry out the old seals being careful not to scratch the wheel shaft sealing area. Then ...