...position sensors next? hello before you replace parts you might not need try to test the map sensor see if it is within range this works with vacuum changes in motor goodluck please rate AUDI A6 ...
...1999 Audi A6 occurred immediately after changing battery why did you charge the battery? is the system charging ?check you cables did you disconect the battery when you charged it? if not check your ...
...press again and it goes great. I have put a new throttle body , cam sensor and have been thu 3 differrent audi shops help please no more $$$$$ DID YOU CHECK THE AIR FILTER, FUEL FILTER & PUMP
...18i 20v find it hard 2 start but if i rev it then it startwat cound that be and then the rev go up and down from 800 to 1300 rev , help just a sugestion you should check the throttle position ...
...sensor, will replacing it and throttle vacuum hoses fix my problem ? Do you also see the shuddering when you hit the gas to pass someone or accelerate quickly? If so, I'd swap out the fuel filter ...
...The throttle position sensor needs to be reset with Vag-Com. This happened to me a couple times and I paid $100 to the dealership both times. Now I have Vag-Com and the OBDII cable and I do it
...throttle body cleaner and replace the air filter. As for the MAF and throttle body cleaner, just follow the instruction on the cans or ask the parts store for advice such as Auto Zone. Auto Zone can ...
...look at the throttle body you will see a small sensor off to one side that has an electrical connector. Ensure it is plugged in. If it is then you may want to replace it. It is quite a simple
...throttle position sensor or throttle body is dirty might have to purchase an air intake spray cleaner to clean your throttle body.. EVAP purge valve stuck open causing over rich cranking condition
Question about 1999 A6
Where is the trottle position sensor for the 1998 audi a6 2.8 located here:
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions