Questions & Answers for: replace thermostat 1994 oldsmobile cutlass

...1994 Oldsmobile Cutlass Ceira 3.1L, Once every 2 weeks the car is very hard to start, so much so that I had burnt out 3 starters and 1 Alternator. After I get the car running it sounds rough until it ...

...replace. If it works find your wiring problem. Have you checked the fan relay?Do the fans come on when you tyrn on the ac?Have you checked the cooling fan fuses?The ansewers to these questons can ...

...replace the thermostat myself or if it needs to be done in the shop. I also not exactly sure where the thernostat is I thought when I changed the hose it would be right inside but it was not. in lass ...

...thermostat. engine does not appear to be hot. could it be an electrical wire causing the gauge to go into the red. You most likely have a blocked radiator based on the vehicle's age, which will not ...

...thermostat. As long as your engine is not over heating (you do not say what temp reading your gauge is indicating) then all is well. The system is doing what it was designed to do. Depending on the ...

...replace thermostat for 1994 cutlass ciera The thermostat is normally located in the aluminium elbow that the top radiator hose connects to. The elbow is usually held down by two bolts and it is only ...

...1994 Oldsmobile Cutlass Ciera 3 0 v6 thermastat Follow the top radiator hose. Where it connects to the engine, there is a thermostat cover. Remove the two bolts and the thermostat is under the

cutlass?? in either case if the problem started after radiator replacement,it sounds like you have air trapped in the system. if you look on the thermostat housing(at the end of top radiator hose that

replace thermostat need the location of the thermostat Follow the top radiator back to the engine at end of it will be the thermostat housing ther will be 2 bolts that mount it to the engine.Remove ...

...replace thermostat Follow the top radiator back to the engine and the thermostat housing will be at the end of the top radiator hose.Remove the 2 bolts and pty the housing off and remove the ...