Questions & Answers for: Maytag Neptune replace a thermistor

Ad

Question about MAH6700AWW Neptune Front-Load Washer

5 Answers

...assist i am there to solve . thank u sir.. please vote me.. the inlet valve has to be checked or replaced if required the inlet valve might be stuck or need to be replaced also check the

Ad

...replace the thermistor, the whole valve has to be changed out. It's easier than you might imagine. All you need is; 1.) Pliers 2.) Phillips screwdriver 3.) 5/16" nut driver/socket 4.) 1/4" nut ...

Ad

Question about MDE9700AYW Neptune 174 Electric Dryer

1 Answer

I have a Maytag Neptune Dryer that won't heat. we replaced the thermistor and the control board. What else could it be? First unplug dryer and test your heating element for continuity with a ...

Question about Neptune Washer

1 Answer

...to pin down. could also possibly be the Water Inlet Valve w/Thermistor #22003834 needs to be replaced due to having Well Water with lots of sand, in the water it is not closing the valve ...

Question about MDE9700AYW Neptune 174 Electric Dryer

1 Answer

...The element should be between 10 and 50 ohms if it's good. The thermistor should be around 10,000 ohms at room temperature and if both check good, replace the control board. Hope this

Question about MDE9700AYW Neptune 174 Electric Dryer

1 Answer

...or dirty vent pipe. If these are clear and you are still getting the code the thermistor would need replaced, the resistance of the thermistor should be about 10K ohms at room temperature. The part ...

Question about MDE9700AYW Neptune 174 Electric Dryer

1 Answer

...or dirty vent pipe.If these are clear and you are still getting the code the thermistor would need replaced, the resistance of the thermistor should be about 10K ohms at room temperature. ...

Question about MDE9700AYW Neptune 174 Electric Dryer

1 Answer

...thermistor is bad. Try measuring it to prove it is OK. It should be 10K Ohms at room temperature (20C / 68F).If necessary, replace it then clear the error code.1. Enter to Service Mode by press CHIME ...

...thermistor is bad by measure the resistance. It should be 10K Ohms at room temperature. If it's bad, replace it BUT you have to CLEAR to error code. 1. Enter to Service Mode by press ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...