Questions & Answers for: Xerox replace a thermistor Computers & Internet

Ad

Question about Phaser 8400 Laser Printer

2 Answers

...thermistor appears to be open. Replace thedrum-temperature sensor. (from http://www.inktechnologies.com/fault_codes.pdf) Where to find it ...

Ad

Question about DocuColor 12 Printer

2 Answers

...Thermistor Inspect the surface of the Heat Roll for excessive wear due to the Thermistor. Replace the Heat Roll if necessary 6.Check the Drawer connector at the rear of the Fuser for damaged ...

Ad

Question about DocuColor 3535 Copier

2 Answers

...thermistor on the fuser has gone bad.Most likely need to replace the fuser module. The part number is 008R12904. You can look in the fuser and see if there is something stuck under the front ...

Question about DocuColor 12 Printer

2 Answers

thermistor connections. then lift the heat roller towards ur side. then remove the preser roller lamp and thermistores. then u replace a preser roller. all the best... i took out the inside of my docu

Question about CopyCentre C20 Black and White Copier

1 Answer

...thermistor in that machine. You can replace the fuser module you can try looking up on google a business called 'The parts drop" call and see if they can sell you just a thermistor. That's not an ...

Question about DocuColor 12 Color Copier

1 Answer

error 10-368 That is a pressure roller thermistor failure. The thermistor that contacts the pressure roll is either very dirty or it has failed. Clean or replace accordingly.

Question about CopyCentre C20 Black and White Copier

1 Answer

open heat error...can I replace on my own? Disassemble fuser and inspect thermistor, thermostat and heat lamp. Replace broken part.

Question about DocuColor 12 Printer

1 Answer

...been followed with no resolution. Thermistor resistance checks were good and the thermistors were replaced. Fuser module PJ 700 pins were not bent. The inboard Plug 700A is mounted in a metal plate ...

Question about Phaser 3100MFP/S Laser Printer

1 Answer

...can be damaged due to overheating Fuser thermistor or try to replace the entire fuser, clean electrical contacts which could cause malfunction of fuser.Este indicated a specialist to handle ...

Question about WorkCentre PRO 128 Copier

1 Answer

...Replace the Fuser Unit Yes)Check the resistance of the Rear Thermistor between P600-2 and P600-4 . The resistance is 3k ohms or higher. No)Replace the Fuser Unit Yes)Check the wire between J410 and ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...