...replace the thermistor and do the same procedure again. .press and hold 08 while turning on the copier reset your C41 by using the "08" mode, code 89, press start key change the figure coming on the ...
...Replace the Thermistor in fuser unit If 1st time occur, u can just go to 08-400, reset the value to "0" then restart the machine. When this code not cleat 08-400 then check these all ...
...(5) Check if the IH board or the switching power supply unit are abnormal. â?¢ Replace the IH control board. 3. Check the LGC board (1) Check if the connectors CN316 are ...
machine appears long beep when i switch on.n show H2 code h2 is the thermistor in the fuser unit is faulty the thermistor and the thermal fuse must be replaced
...thermistor set is bad and would need to be replaced by a qualified tech. If 1st time occur, u can just go to 08-400, reset the value to "0" then restart the machine. When this code not cleat 08-400 ...
...estudio 20 C44 code, burns out thermofuses, or codes out but the equipment is in working order. replaced PWA relay boards, and high voltage units. still no fix. If 1st time occur, u can just go
how to remove earrer c45 toshiba 163 cause c 45 Thermistor abnormality during printing: Abnormality of the thermistor is detected during printing i think replace thermistor
...Is the connector CN310 on the LGC board, or the connector of the drum thermistor disconnected? (5) Replace the drum thermistor. (6) Replace the EPU memory board. (7) Replace the LGC
Question about E-studio 3530c Color Copier. Network Ready Print-scan
toshiba 3530 error 467 Pressure roller thermistor abnormality. check the thermistor or replace it
Usually answered in minutes!
401 Questions
267 Questions
218 Questions
181 Questions
164 Questions