Questions & Answers for: Toyota Tacoma replace a plug

Dealer wants to replace plugs at 30,000 miles on '06 tacoma V-6 Do these plugs need to be replaced or are they good for closer to 100,000 miles it's better safe than sorry, if you replace the plugs ...

...Replace the spark plug cover when all of the spark plugs are replaced. Good luck and hope this helps and The spark plug tension may range between 11 and 15 foot pounds, depending on the size of the ...

time, gap plug, add some antisieze compound to the plug and replace. Add some dieelectric grease inside the plug boot and replace. I would purchase 2 sets of plugs and rotate eveery ten thousand miles

plug, make sure the new plugs are gapped and replace them. It is wise to use some rubber hose to start the new plugs so you don't cross thread. Then replace the plugs and ignition coils. It's probably

...plug then replace with new one then put the lead on that you took off. DO THIS ONE AT A TIME THOUGH AS THEY HAVE TO BE IN A SEQUANCE. and make sure they are spark plugs u want and not heater plugs ...

...plug, replace the plug wire. This ensures that you dont mess up the sequence of the wires which determines which cylinder fires at what time in the cycle. VERY important not to mess up the sequence. ...

...plug ends. If any, replace as necessary. When you replace spark plugs and wires do the following to ensure the firing order remains: Pull one plug at a time. Take plug wire off the plug only, until ...

plug at the bottom of these plugs. Remove and replace the plugs same as before. make sure you reconnect all your hoses and wires to their previous locations. Doublecheck to make sure you reconnect all

...- Fuel injectors may be faulty - Intake air leak Possible Solutions: - Perform Injector Service - Replaced Spark Plugs - Replaced Injectors - Replaced Ignition Coils P0301- Cylinder Number 1

...plug. How I can replace or fix it? Some have a center set screw that you loosen then remove assembly, others are tapped in like a conventional freeze out plug. Once removed, clean and lightly sand ...