...replace the the spark plugs on the V6, you'll need to remove the intake manifold. There is a coil on top of each plug (COP). Check this website for info: ...
replace the spark plug cable as well. It is quite easy the damage old plug wires when removing them to change the spark plugs. A good way to check this is to pull off a spark plug wire (one at a time)
plug/coil you need to replace. The front 3 are very easy to replace. For the back 3, you'll need to remove the upper intake manifold (get a gasket set from the parts store). Assuming it's a COP system
...2 and 5, Could this just be plugs? No, but I would recommend replacing the spark plugs with the correct motorcraft spark plugs, most likely the coil pack is bad. Replace the spark plug wires
...showed "excess flow" on EGR too - that had been cleaned when plugs were replaced. From what you are saying why not replace the plug wire on number one, and check the injector which could be
replace plugs with "correct" plugs will damage be averted to pcm and Coils in an "as yet" un-symptomatic '05 Escape? What are the best plugs for this rf dampening problem? - John I would use ONLY Ford
...replace the spark plug and coil pack for that cylinder. I also replaces the other spark plugs. The escape is now running rough. Any ideas as to why? If the spark plug popped out, other mechanical ...
...good spark plug in the coil, stand back, start the vehicle and look to see if the plug is sparking. DO NOT TOUCH IT WHILE THE VEHICLE IS RUNNING. always replace the spark plug when replacing a ...
cylinder 1 misfire spark plug replaced, plug wire replaces, ignition coil swapped with cylinder 3, but misfire code stays with cylinder 1 Have you tried clearing the code and go from there? Also maybe
...replace plug wires also.you need to replace one spark plug at a time so you wont mix up firing order. you need a spark socket, torque wrench, 3/8 ratchet wrench, 3/8 short and long ...
Usually answered in minutes!
1,139 Questions
1,083 Questions
1,107 Questions
900 Questions
559 Questions