Questions & Answers for: Chrysler 300M replace a plug

...when cold Check the battery condition, battery state of charge and starter motor current draw. Replace the battery if marginal and the starter motor if the current draw is beyond specification. ...

...engine light coming on. I get the following codes P0300, P0132 and P0152. Both o2 sensors have been replaced as well as spark plugs. Codes have been reset. Engine light still comes on. Is the PCM ...

...just pull up on it and it should pop right off the spark plug. Replace the coil and long boot(its one piece) with a new one and you should be good to go. They are about $85 buck at the parts

...from the alt The regulator inside the alt. is bad. Replace the alternator. When you unplug the the small plug youre running on battery. If you plug it in you can start a fire or blowup the

...of two screws on each coil. Take a LONG extension and put on a 5/8" plug socket on it. Use a ratchet to (Lefty-Lucy) the plug. Replace each Plug. Reverse of rip-down. Repeat 5 more times. 

...170K car had misfire in cylinder#2 and rpms would jump between 1000-1500 at idle cel code 302 replaced plug,coil,pcv, ..no more code, rpms don't bounce but car seems to stumble every so ...

...plug problem,click the help links provided below :---Car has no spark?http://schematicsdiagram.blogspot.com/2011/06/car-has-no-spark.html------------How to Replace Spark ...

...so, get the codes read. Pull a plug. Is it wet? If so, engine is flooded. Pull all plugs, and allow to dry, several hours, replace and try again. Check for spark. Spark good? If not, troubleshoot

2002 300m brake, abs, trac off lights on with P0113 code I replaced the starter motor and the battery. The first start was rough and cut off the second start was rough but smoothed out. Before I ...

...plugs in to "read codes".. Mine is broken.. Not sure of correct name of it, so that I can find info to replace mine. Would like to be able to plug things in (Snapshot). OBDII connector, dealer ...