Questions & Answers for: Chevrolet S 10 replace a plug

...replace the plug by pulling the right tire off or do I need to jack truckup to get to freeze plug. both... put some gasket sealer on the outer sides of the new freeze plug before you tap it in. Not ...

in with a socket that will just fit inside the freeze plug. You should replace them both while you are there. Good Luck I have the same truck leaking at back not positive its the freeze plug any ideas

Keeps throwing random/multiple misfire code, blowing plugs and running rich. New plugs, wires, rotor, cap is still good. EGR valve cleaned. New ECM. Fuel pump was replaced a couple months ago. Oh, and

plug and then your going to have to use your fingers to remove an replace it, then use the socket and extension to tighten it again. Don't forget to use anti-seize on the new spark plugs for an easier

misfires #2, replaced plug, wire but still Have a Chevy S10 2002 pick-up and I had the wires replaced, drove it for a week and now it is misfiring on #2, we replaced the plug the wire but it is still ...

...replace the spark plugs and plug wires. It sounds like you have a bad plug wire but replacing all of the plug wires and all the plugs should resolve your issue. Check the distributor gear. Is it a ...

...replace freeze plug on 1984 chevy silverado 305 Clear enough work area around the leaking plug. Using a 1/4" wide chisel, or suitable strong screwdriver, "hook out" the defective plug. Clean and ...

...plug with a pair of plyers and see if it is fireing, If it is fireing of it will cause the motor to boug down when you remove, then replace and will start back running the way it was , Do this on all ...

S 10 1990 won't start, replaced, plugs, wires, timing chain, etc Replaced timing chain, gears, plugs, fuel pump, plug wires, distributor, just not starting hmm check fuses/relays and your starter&

...transmission speed sensor Possible cracked sparkplug insulator. Faulty plug wires. Both can cause a backfire. I would replace the plug wires if they seem worn, and check each plug thoroughly. Good ...